RCA35R

$2349.99

Product Overview

The Morgan RCA35R starts with the circuit from the RCA35 and then adds three spring tube driven reverb. The Morgan RCA35Rwas designed around a special output transformer that is equally happy with 6L6s or 6V6s or EL34s or KT66s or KT77s or 6CA7s. The RCA35’s unique design allows any of these tubes to be swapped in. Simply choose a matched pair and just plug and play. The Cathode Bias design allows you to swap power tubes without the need for rebiasing. The RCA35R has a black face style tone stack. The Bass, Mid, and Treb controls give you a wide range of tones. Do not be afraid to use extreme settings on the tone controls, they are designed to give you the most dramatic swings available to allow you to go from clean and glassy like an EL84 class A amp to thick and grindy like the best plexi you have ever heard.The RCA35R reverb is also run parallel to the original tone stack. This means when the reverb is not being used it is totally out of the circuit unlike most other guitar amp reverbs. The Midrange control on this amp is special. It is designed to behave normally until about the 9 o’clock position on dial, from that point on you will be adding gain along with your midrange giving you a completely different feel and growl. The Master volume on this amp is similar to the ones used in The SW series of Morgan Amps. Once the master volume is over the 2 o’clock position it will start adding gain to the power section of the amp. This amp is a Swiss Army knife. With the ability to swap output tubes at will and the extreme tone controls it is a perfect for the studio or the guitar player that likes to change his rig every week. Handwired in the USA.

Product Specs

• Available as - head or 112 combo
• Power: 35w Class A tube
• Hand-wired in the USA
• 2x 6L6 power tubes (also can use 6V6, EL34, KT66, KT77, 6CA7)
• 3x 12AX7 preamp tubes
• GZ34 Tube Rectified
• 3 spring Tube Driven Reverb
• Bright switch
• Gain, Treble, Mid, Bass and Volume Controls
• 2x8 ohm 1x16 ohm outputs
• Custom USA made Mercury Magnetics transformers
• Limited lifetime warranty
• Made in the U.S.A.

Product Dimensions

• Dimensions: 7.5" (D) x 24" (W) x 9.75" (H)
• Weight: 37 lb.